Planning: Aim The aim of this experiment is to show how the height of a ramp from which a trolley rolls down will affect its run off speed.
0 User(s) Rated!
0 User(s) Rated!
Words: 562
Views: 872
Comments: 0
Planning: Aim The aim of this experiment is to show how the height of a ramp from which a trolley rolls down will affect its run off speed. Preliminary The preliminary experiment we did prior to the investigation enabled me to choose what factors of the investigation I should keep the same or alter. My results from the preliminary displayed that I should perform the following procedures: - ?óÔé¼?¥h The heights that allow the trolley to go down the ramp at a suitable velocity and whereabouts on the ramp I would allow the trolley to...
timing proved to be most accurate:
timing proved to be most accurate:
Height m Time using stopwatchs Time using tickertimer s
10 1.76 1.59
10 1.56 1.47
30 0.67 0.97
30 0.91 1.04
Prediction
I predict that the higher the ramp is the faster the speed of the trolley will be and the average velocity and time will not be directly proportional.
Due to gravitational potential energy GPE which is the amount of energy that an object has because it its position. The higher the object is the more GPE it has and my table below proves
Become a member to continue reading this essay orLogin
Life is sustained by the energy from the sun. Without the sun all plants and animals would die. The sun provides 99.98% of the energy, which naturally flows through the surface environment of the earth. Put another way, the sun supplies 5000 times more energy than all other sources combined....
Words: 549
View(s): 1294
Comment(s): 0
A trolley is positioned the top of a ramp, the summit being Xcm from the ground. It is then released, rolling all the way down the ramp which is a set length, then comes in to contact with the ground and travels a distance of 2 meters before it...
Words: 3484
View(s): 3588
Comment(s): 0
The aim of this experiment is to find out if the resistance of a piece of wire will change if we vary the length. To do this I will set up a circuit that will include an ammeter, a voltmeter and a piece of wire. The wire will be a...
Words: 862
View(s): 936
Comment(s): 0
Aim: In my experiment I am aiming to discover what happens to the resistance of a wire as the length is changed. Independent variables - Length of wire - Diameter of wire - Material of wire The factor I will be investigating is length. I have chose not to investigate...
Words: 534
View(s): 1306
Comment(s): 0
The following shows the collision theory used to explain the effect of temperature and concentration Prediction: In this investigation I expect to find as I increase the temperature the reaction will take place faster. This is because as the temperature increases, it gives more energy to the sodium thiosulphate and...
Words: 1538
View(s): 1255
Comment(s): 0